RE: Re: Re: QRPLOBJ Help, reply to Vernon Hamberg

                                                                                
                   
                                                                                
                   
                                                                                
                   
                                                                                
                   
                                                                                
                   
                                                                                
                   
  I had the same problem that was described here.                               
                   
                                                                                
                   
                                                                                
                   
  After I spent some time searching for a solution, I finally found the cause 
of all the *USRSPC   
  objects in QRPLOBJ.                                                           
                   
                                                                                
                   
                                                                                
                   
  My problem was that I used the "Iseries Job Status" View (Window -> Show View 
-> Other... ->     
  Iseries\Iseries Job Status), with a refresh interval of 10 seconds in 
combination with the       
  option "Add batch compiles to the Iseries Job Status view" and "Add batch 
commands to the        
  Iseries Job Status view" (Window -> Preferences -> Remote Systems -> Iseries 
-> Command          
  Execution).                                                                   
                   
                                                                                
                   
                                                                                
                   
  These settings resulted in a *USRSPC object that was written every 10 seconds 
in QRPLOBJ. When I 
  increased the refresh interval to 1 minute, a *USRSPC object was written 
every minute...         
                                                                                
                   
                                                                                
                   
  So there were 2 solutions for me to avoid all the *USRSPC objects:            
                   
                                                                                
                   
                                                                                
                   
  1) Turn off the Command Execution preferences: no adding to the Iseries Job 
Status view.         
                                                                                
                   
                                                                                
                   
  2) Set the refresh interval in the Iseries Job Status View to Never (only 
when I do a manual     
  refresh I get a *USRSPC object).                                              
                   
                                                                                
                   
                                                                                
                   
  Hope this helps...                                                            
                   
                                                                                
                   
                                                                                
                   
  I don't know if the *USRSPC objects are normal "side effects", perhaps the 
WDSc developing team  
  can tell us?!