This message is in MIME format. Since your mail reader does not understand this format, some or all of this message may not be legible. -- [ Picked text/plain from multipart/alternative ] Thanks all... Yes I recall folks talking about WRKSYSACT in an earlier discussion on compiling interactively. I'm still in the process of obtaining that command (no duals here). Hopefully it's available as part of software subscription. Speaking of govenors, anyone using or familiar with FAST/400? Alan -----Original Message----- From: Jim Langston [mailto:email@example.com] Sent: Thursday, October 10, 2002 5:46 PM To: 'firstname.lastname@example.org' Subject: RE: [SYS21] Corrected copy Instead of using WRKACTJOB, use WRKSYSACT (Work System Activity) which will show all jobs. You should notice a job called CFINT01 taking up a *lot* of CPU time when this happens. Normally, CFINT01 takes up minimal CPU time, 1.3 or so, but when the governor kicks in it eats up tremendous amounts of CPU time, I've seen it up to like 87% CPU. Understand, all CFINT01 is doing at those times is wasting CPU cycles so you can't use 'em. This is the dreaded "governor". Regards, Jim Langston -----Original Message----- From: Doug333@aol.com [mailto:Doug333@aol.com] Any chance this is one of those iSeries with the 'guvner' on it? If you go over the workload you purchased from IBM, artificial jobs kick in and drive the CPU up to 100%. Grrrr! _______________________________________________ This is the GEAC/JBA System 21 Users (JBAUSERS-L) mailing list To post a message email: JBAUSERS-L@midrange.com To subscribe, unsubscribe, or change list options, visit: http://lists.midrange.com/cgi-bin/listinfo/jbausers-l or email: JBAUSERS-Lemail@example.com Before posting, please take a moment to review the archives at http://archive.midrange.com/jbausers-l. ================================================================== This electronic message transmission, including any attachments, contains information from KI(USA) Corporation which may be confidential or privileged. These contents are intended solely for the use of the individual or entity to whom it is addressed. If you are not the intended recipient you must not copy, distribute, or take any action in reliance on it. If you have received this electronic transmission in error, please notify the sender immediately by a "reply to sender only" message and destroy all electronic and hard copies of the communication, including attachments. KI(USA) Corporation uses an anti-virus system and therefore any files sent via e-mail will have been checked for known viruses. You are however advised to run your own virus check before opening any attachments received as KI(USA) Corporation will not accept any liability once an e-mail and/or any attachment is received.