I have been using RPG triggers to sync other files. Works great.
When a user enters/updates a customer address (using vendor maintenance
screens) I want to scrub the data using Works Right address verification.
On a Before Update trigger I would take new data, scrub it and change the
data stream so when it updates it uses the new corrected data.
I seem to remember there was something "special" I needed to do that
allows me to change the data stream.
Am I mis-remembering or is that correct?
I can't change the vendor pgms and scrub it there so I have to deal with
Information Technology Team
608-781-6355 EXT 2530
Subject to Change Notice:
WalzCraft reserves the right to improve designs, and to change
specifications without notice.
This message and any attachments may contain confidential and privileged
information that is protected by law. The information contained herein is
transmitted for the sole use of the intended recipient(s) and should "only"
pertain to "WalzCraft" company matters. If you are not the intended
recipient or designated agent of the recipient of such information, you are
hereby notified that any use, dissemination, copying or retention of this
email or the information contained herein is strictly prohibited and may
subject you to penalties under federal and/or state law. If you received
this email in error, please notify the sender immediately and permanently
delete this email. Thank You;
WalzCraft PO Box 1748 La Crosse, WI. 54602-1748
www.walzcraft.com<http://www.walzcraft.com/> Phone... 800-237-1326
This is the RPG programming on the IBM i (AS/400 and iSeries) (RPG400-L)
To post a message email: RPG400-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
or email: RPG400-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
Please contact support@xxxxxxxxxxxx for any subscription related
Help support midrange.com by shopping at amazon.com with our affiliate