I have been using RPG triggers to sync other files. Works great.
When a user enters/updates a customer address (using vendor maintenance screens) I want to scrub the data using Works Right address verification.
On a Before Update trigger I would take new data, scrub it and change the data stream so when it updates it uses the new corrected data.
I seem to remember there was something "special" I needed to do that allows me to change the data stream.
Am I mis-remembering or is that correct?
I can't change the vendor pgms and scrub it there so I have to deal with it downstream.
Information Technology Team
608-781-6355 EXT 2530
Subject to Change Notice:
WalzCraft reserves the right to improve designs, and to change specifications without notice.
This message and any attachments may contain confidential and privileged information that is protected by law. The information contained herein is transmitted for the sole use of the intended recipient(s) and should "only" pertain to "WalzCraft" company matters. If you are not the intended recipient or designated agent of the recipient of such information, you are hereby notified that any use, dissemination, copying or retention of this email or the information contained herein is strictly prohibited and may subject you to penalties under federal and/or state law. If you received this email in error, please notify the sender immediately and permanently delete this email. Thank You;
WalzCraft PO Box 1748 La Crosse, WI. 54602-1748
> Phone... 800-237-1326