Re: sndmsg from rpg working but no message

[Denny Ray <DennyRay@xxxxxxxxxxxxx>]

'SNDMSG MSG('''Billing batch 1714B entered on 07/14/10 has not been 
updated''') TOMSGQ(DALE )'

Booth Martin wrote:
> What happens if you prompt the message, it goes to the right place, and 
> then you F9 on the command line?  Does that look like you expect it to look?
>
> On 7/15/2010 4:22 PM, dale janus wrote:
>   
> > After much tweaking, I finally have my RPG program calling QCMDEXC and
> > sending a properly formatted message.  I had problems with the length
> > parm (I had 15s 5, it must be 15p 5).  Debug shows I have a properly
> > formatted command with quotes and everything.
> >
> > SNDMSG MSG(' Billing batch 1714B entered on 07/14/10 has not
> >   been updated ' ) TOMSGQ(DALE      )
> >
> >
> > After all that work, the message does not appear to be sent.
> >
> >
> > If I type SNDMSG and prompt at the command line it sends the message.
> >
> > If I paste the command above and press enter,  it never appears in the
> > message que.
> >
> > So what am I missing here?
> >
> > My RPG program is reading a file that has the user name that I put into
> > the TOMSGQ parm.  I suppose I could change it to workstation name and
> > try sending a break message, but I don't see how that would work any
> > differently.
> >
> > Where is the message going to?
> >
> > ---Dale
> >
> >
> >
> >
> >
> >