If you truly don't care about the state of the indicators, then just
turn them all off in the *inzsr subroutine or something like that. That
will define them and allow the program to compile.
But is sounds to me like it is time for a re-write.
Good luck.
---Dale
Subject:
How do I define *IN13, *in82 etc
From:
Alan Shore <AlanShore@xxxxxxxx>
Date:
Wed, 8 Jul 2009 11:00:19 -0400
To:
RPG programming on the IBM i / System i <rpg400-l@xxxxxxxxxxxx>
Morning all
I'm hoping that I wont need to go into too much detail, so here goes
We have a program that uses a workstation (DSPF)
To cut a LOOOOOOOONNNNNNGGGGGG story short, the program does NOT display
ANY of the screens from this display file
Where ever there is an EXFMT, there is code to "jump" around the EXFMT - I
hasten to add NOT MY DESIGN
We now have a reason to remove this DSPF (workstation) from the program.
Any fields used within the program from the DSPF, I am just defining in the
D specs
However, indicators like *IN13, *IN82 *INKC *INKF etc. etc. are now
receiving the RNF7030 compile error (NOT DEFINED)
Rather than try and change the logic within the program, the question is
How can I define these indicators (that is if I can)?
Any help (as always) will be MUCH appreciated
Alan Shore
Programmer/Analyst, Distribution
E:AShore@xxxxxxxxxxx
P:(631) 200-5019
C:(631) 880-8640
"If you're going through Hell, keep going" - Winston Churchill
midrange.com
