Re: Runs in debug only

Are you sure that you have the LR at Total level?
LR at Detail level can be specified, but unless you set it on manualy, it will never be executed.
If it is at the Total level, when you run in Debug, is LR on?
The statement can be set at a break point in debug and will stop even if it is not being executed due to it not being LR Total time.
 
Jeff Young
Sr. Programmer Analyst
IBM -e(logo) server Certified Systems Exper - iSeries Technical Solutions V5R2 
IBM  Certified Specialist- e(logo) server i5Series Technical Solutions Designer V5R3
IBM  Certified Specialist- e(logo)server i5Series Technical Solutions Implementer V5R3
  
 






________________________________
From: John Furniss <JFurniss@xxxxxxxxxxxxxxxxx>
To: RPG programming on the IBM i / System i <rpg400-l@xxxxxxxxxxxx>
Sent: Friday, March 27, 2009 11:28:56 AM
Subject: Runs in debug only

List



I have a very simple RPGLE program that simply does a READ to get the
one and only record in a file, then uses that value to CHAIN to another
file, then if the CHAIN fails, does an EXCEPT to print a line on a
report. Very simple. I noticed that the verbiage was not being printed
when I knew it should have been, so I put it in DEBUG mode, stopped it
at the READ statement (which is in a group of LR statements if that
makes any difference) then stepped through with F10. When I do this the
program works as designed. But, when I run the job without debug, the
EXCEPT is never called. Has anyone seen this? I noticed this same
problem a few times in the past, but when I ran it in debug, it seemed
to 'flip a switch' and any subsequent runs would work fine. But this
only works in debug mode. I searched the archives but came up empty.
What am I missing?



Thanks much,



John Furniss

Applications Programmer

Allied Machine & Engineering, Corp

Phone: 330-343-4283, ext. 8371

email: jfurniss@xxxxxxxxxxxxxxxxx