On 07/08/2008, at 11:42 PM, Lim Hock-Chai wrote:

Hhhmm. Didn't think about that when I decided to use *RQS. The main
reason I was avoiding *DIAG is because it might shows up in the joblog
and *DIAG command could give an impression of something is wrong. Since
I have code to remove the message, I guess I'll just change it to use
*DIAG. Thanks.

If you don't like *DIAG then send an *INFO message. Make the text something obvious so if it is left in the job log it won't matter. Perhaps "Are you there?".

Regards,
Simon Coulter.
--------------------------------------------------------------------
FlyByNight Software OS/400, i5/OS Technical Specialists

http://www.flybynight.com.au/
Phone: +61 2 6657 8251 Mobile: +61 0411 091 400 /"\
Fax: +61 2 6657 8251 \ /
X
ASCII Ribbon campaign against HTML E-Mail / \
--------------------------------------------------------------------




This thread ...

Replies:

Follow On AppleNews
Return to Archive home page | Return to MIDRANGE.COM home page

This mailing list archive is Copyright 1997-2019 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].