Re: Dynamic 'callp'

Hello Peter,

Thanks a lot. I have modified the statements as below & it works fine now.


cmd = 'call '+%trim(VARPGMNM)+' PARM(SCINPUT)';
callp(e) qcmdexc(cmd:%len(%trim(cmd)));

Ewart










Peter.Colpaert@xxxxxxxxx
Sent by: rpg400-l-bounces@xxxxxxxxxxxx
08/07/2007 03:15 PM
Please respond to
RPG programming on the AS400 / iSeries <rpg400-l@xxxxxxxxxxxx>

To
RPG programming on the AS400 / iSeries <rpg400-l@xxxxxxxxxxxx>
cc

Subject
Re: Dynamic 'callp'





Ewart,

I don't think you can do this, because the compiler needs to check the
prototype at compile time.

And if it can't determine which program you're going to call, it cannot
know if the prototype is correct.

HTH,

Peter Colpaert
Application Developer
PLI - IT - Kontich, Belgium
-----
Yoda of Borg are we. Futile is resistance, assimilated will you be.
-----



ewart.desouza@xxxxxxxxxxx
Sent by: rpg400-l-bounces@xxxxxxxxxxxx
07/08/2007 11:42
Please respond to
RPG programming on the AS400 / iSeries <rpg400-l@xxxxxxxxxxxx>


To
RPG programming on the AS400 / iSeries <rpg400-l@xxxxxxxxxxxx>
cc

Subject
Dynamic 'callp'






Hello All,

There may be some simple solution for this but I can't seem to get it. The

program I need to call through the 'callp' statement needs to be dynamic.

The following statement runs fine:
callp PGM515(SCINPUT);

Now the same statement calling program PGM515 above should be dynamic
like:
'callp '+%trim(VARPGMNM)+'(SCINPUT)';

Is this possible ???

Thanks & best regards
Ewart
--
This is the RPG programming on the AS400 / iSeries (RPG400-L) mailing list
To post a message email: RPG400-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/rpg400-l
or email: RPG400-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/rpg400-l.


--
This is the RPG programming on the AS400 / iSeries (RPG400-L) mailing list
To post a message email: RPG400-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/rpg400-l
or email: RPG400-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/rpg400-l.