Re: Sub-Procedures

This is probably a very rudimentary question about sub-procedures (
have not used them in the past) and I am going through the IBM Red
Book, but as for setting up the source physical file, am I correct in
the assumption that a sub-procedure, when it is a standalone module,
is still created as you would normally create an RPGLE program?

**********************************************************************
******
This transmission may contain information that is privileged,
Confidential and/or exempt from disclosure under applicable law.
If you are not the intended recipient, you are hereby notified that
any disclosure, copying, distribution, or use of the information
contained herein (including any reliance thereon) is STRICTLY
PROHIBITED. If you received this transmission in error, please
immediately contact the sender and destroy the material in its
entirety, whether in electronic or hard copy format. Thank you.
**********************************************************************
******