RE: Program won't Compile

In this case there wasn't an error message in the joblog other than the one
I listed which said to look for other non-existent messages in the joblog.
Had there been, I would have understood what was happening, sooner.

I do appreciate your help, though.  Thank you.

Rick Weber  |  TOYS 'Я' US International 


-----Original Message-----
From: Richard ECUYER [mailto:recuyer@xxxxxxx] 
Sent: Thursday, December 14, 2006 11:36 AM
To: RPG programming on the AS400 / iSeries
Subject: Re: Program won't Compile

When you get a binding error (unable to resole, more than one xxx proceudre
...) the explaination are in the QPJOBLOG not in the listing compil.
----- Original Message ----- 
From: "Weber, Richard" <Weberr@xxxxxxxxxxx>
To: "'RPG programming on the AS400 / iSeries'" <rpg400-l@xxxxxxxxxxxx>
Sent: Thursday, December 14, 2006 5:15 PM
Subject: Program won't Compile

I can't figure this one out.  I made a minor programming change to an

RPGLE

program.  I set up my library list to compile it.  The compile fails.  The
spool file says:

Errors were found during the binding step. See the job log for more
information.

Ok so I go to the Joblog, like it says, and I see:

Message . . . . :   Job ended. Cancel message received at command

processor.

Cause . . . . . :   A message with a severity equal to or exceeding the

end

  severity was received at the command processor. Recovery  . . . :   See
the messages previously listed to determine the message that caused the

job

to be ended. Correct the errors, and then try the request again.

Unfortunately, there are no previously listed messages except the job
submitted message.  So, what's the problem??  The only thing I noticed is
that while the job was sitting on the qbatch subsystem, it was in LCKW

state

and I can't figure out why and neither the joblog or listing want to give

me

any helpful information.

Rick Weber  |  TOYS 'Я' US International

========================================================================
This email message is for the sole use of the intended recipient (s) and

may

contain confidential and privileged information. Any unauthorized review,
use, disclosure or distribution is prohibited. If you are not the intended
recipient, please contact the sender by reply email and destroy all copies
of the original message. To reply to our email administrator directly,

send

an email to EmailAdmin@xxxxxxxxxxxx
Toys "R" Us, Inc.

-- 
This is the RPG programming on the AS400 / iSeries (RPG400-L) mailing list
To post a message email: RPG400-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/rpg400-l
or email: RPG400-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/rpg400-l.