RE: Tool to convert Subroutine to SubProcedure

Scott is correct. The Linoma tool will change the specification type to 'X'
(which is invalid) for any Return opcode it finds in a subprocedure that it
converted, which will force you to rework the logic, because the program
will not compile until you do.


Francis 



-----Original Message-----
From: rpg400-l-bounces@xxxxxxxxxxxx [mailto:rpg400-l-bounces@xxxxxxxxxxxx]
On Behalf Of Holden Tommy
Sent: Thursday, April 20, 2006 2:33 PM
To: RPG programming on the AS400 / iSeries
Subject: RE: Tool to convert Subroutine to SubProcedure

OK so I'm confused....LOL 


Thanks,
Tommy Holden


-----Original Message-----
From: rpg400-l-bounces@xxxxxxxxxxxx
[mailto:rpg400-l-bounces@xxxxxxxxxxxx] On Behalf Of Scott Klement
Sent: Thursday, April 20, 2006 2:29 PM
To: RPG programming on the AS400 / iSeries
Subject: RE: Tool to convert Subroutine to SubProcedure


> Yes but bear in mind when converting termination subroutines the *INLR 
> will NOT function as it was intended.  Each procedure/subprocedure has 
> it's own *INLR so if you expect *INLR in a subprocedure to unload your 
> program....you're wrong....

Sorry, this just isn't true.  There's a separate *INLR for each module, but
not for each subprocedure!

You may be confusing *INLR with the RETURN op-code.
--
This is the RPG programming on the AS400 / iSeries (RPG400-L) mailing list
To post a message email: RPG400-L@xxxxxxxxxxxx To subscribe, unsubscribe, or
change list options,
visit: http://lists.midrange.com/mailman/listinfo/rpg400-l
or email: RPG400-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives at
http://archive.midrange.com/rpg400-l.