RE: elapsed time

Also, you might want to increase DBENCHSECS to 5,0, because at 4,0, it will
cause a run-time overflow for anything over 2 hours, 46 minutes and 11
seconds (9999 seconds).

-----Original Message-----
From: rpg400-l-bounces@xxxxxxxxxxxx [mailto:rpg400-l-bounces@xxxxxxxxxxxx]
On Behalf Of Lapeyre, Francis
Sent: Wednesday, November 16, 2005 8:35 AM
To: 'RPG programming on the AS400 / iSeries'
Subject: RE: elapsed time

Define BENCH as type Z (timestamp), not type T (time).

Francis Lapeyre
IS Dept. Programmer/Analyst
Stewart Enterprises, Inc.
E-mail: flapeyre@xxxxxxxx 

 

-----Original Message-----
From: rpg400-l-bounces@xxxxxxxxxxxx [mailto:rpg400-l-bounces@xxxxxxxxxxxx]
On Behalf Of Yivi
Sent: Wednesday, November 16, 2005 8:29 AM
To: RPG programming on the AS400 / iSeries
Subject: elapsed time

Hello everyone.
 I am trying to print a basic timing on how long does a particular program
takes to do its stuff.
Since the program runs for several minutes, I am not concerned in anything
more precise than seconds.
 I did the following:

DBENCH S T
DBENCHSECS S 4 0
/FREE
BENCH = %TIME;
// a whole lot of program
// many reads, calculations and writes

BENCHSECS = %DIFF(BENCH:%TIME:*SECONDS); write ENDOFREPORT; *INLR = *ON;

//END-FREE
*ENDOFREPORT* includes the *BENCHSECS* field. And the problem is that it
keeps coming as zero.
It's probably something quite idiotic, as the results of %TIME not being the
kind of results that I think I want.
 Any ideas?
 Thanks again, regards.
 I.-
--
This is the RPG programming on the AS400 / iSeries (RPG400-L) mailing list
To post a message email: RPG400-L@xxxxxxxxxxxx To subscribe, unsubscribe, or
change list options,
visit: http://lists.midrange.com/mailman/listinfo/rpg400-l
or email: RPG400-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives at
http://archive.midrange.com/rpg400-l.
--
This is the RPG programming on the AS400 / iSeries (RPG400-L) mailing list
To post a message email: RPG400-L@xxxxxxxxxxxx To subscribe, unsubscribe, or
change list options,
visit: http://lists.midrange.com/mailman/listinfo/rpg400-l
or email: RPG400-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives at
http://archive.midrange.com/rpg400-l.