Re: [Fwd: A question about subfile operations]

>> I am curious why you make your standard a one-page instead of load-all?

I didn't. Just happened to be what I need for this job. I, also, use a Standard 
Load_All_Subfile Panel. Just didn't need it for this job. 

Most of the time I use a single page load because I have a lot of data to load 
and I want to be able to roll forward and back without waiting for the whole 
subfile to load. Given the way I write the code, using a single page vs. load 
all is no more work than another. 90% of the code is the same. Just pick my 
poison based on what I need for the problem at hand. If I have a given amount 
of data or a small amount, I could use a load all but usually a load all isn't 
going to need the position to and other stuff.