RE: Processing ....please wait

["Tyler, Matt" <mattt@xxxxxxxxxxxxxx>]

In your display file add the keyword FRCDTA to the record you want to
display at anytime.  In your program perform a write just before doing what
causes it to sit and wait.   One benefit over using Mark's suggestion of
sending a status message is that subsequent status messages will not replace
your "Processing...please wait " message.  

Thank you,
Matt Tyler
WinCo Foods, LLC
mattt@xxxxxxxxxxxxxx


-----Original Message-----
From: rpg400-l-bounces@xxxxxxxxxxxx [mailto:rpg400-l-bounces@xxxxxxxxxxxx]
On Behalf Of Fleming, Greg (ED)
Sent: Wednesday, April 27, 2005 8:25 AM
To: rpg400-l@xxxxxxxxxxxx
Subject: Processing ....please wait

I'm trying to figure out how to display a screen without requiring the
program to wait for a response.  

 

The idea is to display "Processing...please wait" while a program is
called to process data, then returns a few seconds later with results to
display.

 

I found something on this topic in the archives, but unfortunately it
was only a discussion of whether it would be better to use SNDPGMMSG or
display a whole screen.  I would prefer the latter, but don't know how
to go about it.  

 

Any suggestions ? 

 

 

Greg Fleming

Programmer/Analyst

Everglades Direct, Inc.

720 International Parkway

Sunrise, FL 33325

954.514.2258

954.851.1201 Fax

gfleming@xxxxxxxxxxxxxxxxxxxx

 

-- 

This is the RPG programming on the AS400 / iSeries (RPG400-L) mailing list
To post a message email: RPG400-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/rpg400-l
or email: RPG400-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/rpg400-l.