Re: RPG error

[RPower@xxxxxxxxxx]

Another thing you can do is compile with Debugging Views set to *SOURCE. 
DBGVIEW(*SOURCE).  Then run the program again and you should get the line 
number of the SOURCE that is causing the issue.


Ron Power
Programmer
Information Services
City Of St. John's, NL
P.O. Box 908
St. John's, NL
A1C 5M2
Tel: 709-576-8132
Email: rpower@xxxxxxxxxx
Website: http://www.stjohns.ca/
___________________________________________________________________________
Success is going from failure to failure without a loss of enthusiasm. - 
Sir Winston Churchill




"Muralidhar Narayana" <Muralidhar_Narayana@xxxxxxxxxxx> 
Sent by: rpg400-l-bounces@xxxxxxxxxxxx
01/02/2005 03:50 PM
Please respond to
RPG programming on the AS400 / iSeries <rpg400-l@xxxxxxxxxxxx>


To
<rpg400-l@xxxxxxxxxxxx>
cc

Subject
RPG error






I got the below error
Function check. MCH1210 unmonitored by YIPXS2R at statement 0000000669,
   instruction X'0000'. 
 The target for a numeric operation is too small to hold the result (C G D 

   F). 
 The target for a numeric operation is too small to hold the result (C G D 

   F). 
 
   YIPXS2R is an SQLRPGLE  program having 428 lines.
I compiled the program to find out exact statement which is the cause for 
above error.
>From the below statements I can see 669 statement, but its nt doing any 
calculations to suspect the statement 669. How can I find out exact 
statetment  which is the cause for above error.
661 C                   PARM                    SQL_00088 
662 C     SQL_00091     IFEQ      '1' 
663 C                   EVAL      XXMONTH = SQL_00098 
664 C                   END 
665 
666  *--------------------------------------------- 
667  * If first entry is equal to cur month, leave 
668  *--------------------------------------------- 
669 C                   IF        XXYear  = XYearCur  and 
670 C                             XXMonth = XMonthCur 
671 C                   LEAVE 
672 C                   ENDIF 
 
2nd level help text says below:
Message . . . . : The target for a numeric operation is too small to hold 

the result (C G D F). 

Cause . . . . . : RPG procedure YIPXS2R in program YTRPROD/YIPXS2R at 

statement 669 performed an arithmetic operation which resulted in a value 

that is too large to fit in the target. If this is a numeric expression, 

the overflow could be the result of the calculation of some intermediate 

result. 

 

-- 
This is the RPG programming on the AS400 / iSeries (RPG400-L) mailing list
To post a message email: RPG400-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/rpg400-l
or email: RPG400-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/rpg400-l.