Re: Message Reply

I agree.  However if you had good monitoring within your program you'd 
rarely, if ever, have a need for *PSSR.  Just a baby walk on the steps to 
get this cleaned up I suppose.

I'd start here:
http://publib.boulder.ibm.com/infocenter/iseries/v5r3/ic2924/index.htm
Programming
  APIs
    APIs by category
      Message handling
Might be the Send Reply Message API.

Rob Berendt
-- 
Group Dekko Services, LLC
Dept 01.073
PO Box 2000
Dock 108
6928N 400E
Kendallville, IN 46755
http://www.dekko.com





Tony Carolla <carolla@xxxxxxxxx> 
Sent by: rpg400-l-bounces@xxxxxxxxxxxx
10/18/2004 12:48 PM
Please respond to
RPG programming on the AS400 / iSeries <rpg400-l@xxxxxxxxxxxx>


To
RPG programming on the AS400 / iSeries <rpg400-l@xxxxxxxxxxxx>
cc

Fax to

Subject
Re: Message Reply






I am not certain about replying to the messages, but if these are
exception/error messages, another idea might be to have your
programmers monitor for these messages in their code.

There are so many ways to test for error conditions, with *PSSR
subroutines, monitor groups, etc. that this may be a better way,
rather than chasing the messages after the errors happen.

Just an idea. 


-- 
"Enter any 11-digit prime number to continue..."
--
This is the RPG programming on the AS400 / iSeries (RPG400-L) mailing list
To post a message email: RPG400-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/rpg400-l
or email: RPG400-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/rpg400-l.