× The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.


  1.  Home
  2. RPG400-L
  3. September 2004

RE: Commitment control and open data paths with triggers

That would work too.  Then I wouldn't have to close and re-open anything. 
I've done it before to open a file for both RRN and key sequence.

Regards,

Mark

> ----- Message from "Lim Hock-Chai" <Lim.Hock-Chai@xxxxxxxx> on Thu, 
> 30 Sep 2004 12:58:16 -0500 -----
> To: "RPG programming on the AS400 / iSeries" <rpg400-l@xxxxxxxxxxxx>
> Subject: RE: Commitment control and open data paths with triggers
> 
> Note: haven't had a chance to test below yet.
> 
> can you declare two F specs that refer to that same file TESTH.  One
> under commitment control the other doesn't.
> If TCommitLock <> '0'
>    use the file that is under commitment control
> otherwise
>    use the file that is not under commitment control
> endif

As an Amazon Associate we earn from qualifying purchases.

This thread ...
Follow On AppleNews
Return to Archive home page | Return to MIDRANGE.COM home page

This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].

Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.