Re: The target for a numeric operation is too small to hold the result t (C G D F)

[RPower@xxxxxxxxxx]

The result field should be large enough to hold the largest possible value 
you could have.  In other words, 17,6 if you added two numbers say 3,0 
each, 999 + 999 = 1998 which would be a 4,0 field.  Because they are all 
the same length, the resulting field could be a whole lot larger.  17,6 
largest value would be 999999999.999999 so you can figure out what you 
might need to use for the result.  Probably 19,6 and use Eval(h) to round 
it off.

Ron Power
Programmer
Information Services
City Of St. John's, NL
P.O. Box 908
St. John's, NL
A1C 5M2
Tel: 709-576-8132
Email: rpower@xxxxxxxxxx
Website: http://www.stjohns.ca/
___________________________________________________________________________
Success is going from failure to failure without a loss of enthusiasm. - 
Sir Winston Churchill




"Hatzenbeler, Tim" <thatzenbeler@xxxxxxxxxxxxx> 
Sent by: rpg400-l-bounces@xxxxxxxxxxxx
07/16/2004 04:38 PM
Please respond to
RPG programming on the AS400 / iSeries <rpg400-l@xxxxxxxxxxxx>


To
"'RPG programming on the AS400 / iSeries'" <rpg400-l@xxxxxxxxxxxx>
cc

Subject
The target for a numeric operation is too small to hold the resul t (C G D 
F)






                 I'm getting this error....  Is there an H spec to remove 
it, or do I
use an error code to trap it.?

                 The target for a numeric operation is too small to hold 
the result
(C G D F)

                 c                   eval      p_P_tax_var  =

                 c (g_g_txamount-linetax)/linetax


                 All four of these variables, are defined ast 17,6  So I'm 
ok, if I
have to drop accuracy after 7 places..

                 Thanks, tim

This e-mail message, including any attachments, is for the sole use of the
intended recipient(s) and may contain confidential or privileged
information.  Any unauthorized review, use, disclosure or distribution is
prohibited.  If you are not the intended recipient, please contact the
sender by reply e-mail and destroy the message.
--
This is the RPG programming on the AS400 / iSeries (RPG400-L) mailing list
To post a message email: RPG400-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/rpg400-l
or email: RPG400-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/rpg400-l.




This OutBound email has been scanned for Viruses