Re: F22 and a service program

["Denis Robitaille" <denis_robitaille@xxxxxxxxxxxx>]

Put a break point in the calling program on the statement that calls the
service program then use F22 to step into the service program.

Denis Robitaille
Directeur services technique TI
819 363 5187

>>> Michael.Smith3@xxxxxxxx 03/04/03 12:00pm >>>
I am having a problem debugging a service program.
 
I enter debug on the calling program, add a break point, use F14 to add
the service program, add breakpoints within the service program(1st H
spec, begining of the procedure, 1st calculation within the procedure,
end of the procedure) and then execute the calling progam.
 
F22 does not move into the service program.
 
Service program information:
1> Runs in its own activation group
2> Module that was used to create the service has DEBUG *YES
 
Any suggestions on what my next steps should be?
 
Michael 
_______________________________________________
This is the RPG programming on the AS400 / iSeries (RPG400-L) mailing
list
To post a message email: RPG400-L@xxxxxxxxxxxx 
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/rpg400-l 
or email: RPG400-L-request@xxxxxxxxxxxx 
Before posting, please take a moment to review the archives
at http://archive.midrange.com/rpg400-l.