RE: SQLRPGLE - Dynamic selection

["Tracy Ball" <TBall@xxxxxxxxxxxxxxxx>]

Mark,

After further analyzing the source, I think the fact that I exclude the %trim 
%bif from the select statement might be the problem.  Not quite sure, however, 
I will start small and build up, utilizing the error codes as well.  Thanks for 
a great example!

-Tracy 
 Ext. 3107


-----Original Message-----
From: MWalter@xxxxxxxxxxxxxxx [mailto:MWalter@xxxxxxxxxxxxxxx]
Sent: Tuesday, February 25, 2003 1:03 PM
To: RPG programming on the AS400 / iSeries
Subject: RE: SQLRPGLE - Dynamic selection



Tracy,

Basically the null indicators are there to stop a job log entry from being
written. This procedure runs numerous times and before I put the null
indicators in, the job was creating huge joblogs.


Good Luck,

Mark


Mark Walter
Sr. Programmer/Analyst
Hanover Wire Cloth a div of CCX, Inc.
mwalter@xxxxxxxxxxxxxxx
http://www.hanoverwire.com
717.637.3795 Ext.3040
/"\
\ /
 X
/ \


_______________________________________________
This is the RPG programming on the AS400 / iSeries (RPG400-L) mailing list
To post a message email: RPG400-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/rpg400-l
or email: RPG400-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/rpg400-l.