RE: SNDNETSPLF losing job attributes

[MBarton@xxxxxxxxxx]

>Yes, we are attempting to go from one AS400 to another.  One of our
>programmers used the *ALLDATA parm but the spool file arrived at the target
>system without it's job attributes.  Both machines releases are later than
>V1R3M0.  R.

Hi
     I think tere may be a slight mis-understanding going on.

The spool file on the target as/400 will always be 'attached' to
a job name of QPRTJOB which the system automatically creates.
The original job attributes will be lost.
No parameter on the SNDNETSPLF will AFAIK make any difference.

I did try using the QSPGETF and QSPPUTF programs to see if these
were able to keep the original job attributes but they don't.

All you could possibly do is to save the original spool information
on the source as400 and hold these in some form of lookup table on
the target as400.

Mike



This communication and the information it contains: - (a) Is intended for the 
person(s) or organisation(s) named above and for no other person(s) or 
organisation(s).  Access to this mail by anyone else is unauthorised.  (b) Is 
confidential, and may be legally privileged or otherwise protected in law. 
Unauthorised use, circulation, copying or disclosure of any part of this 
communication may be unlawful.  (c) May be susceptible to interference, and 
should not be assumed that it has come in its original form and/or from the 
stated sender or PinkRoccade UK accepts no responsibility for information, 
errors or omissions in this e-mail or use or misuse thereof or any act done or 
omitted to be done in connection with this communication. If you are not the 
intended recipient, please inform postmaster@pink.co.uk immediately and delete 
it and all copies from your system.
_____________________________________________________________________
This message has been checked for all known viruses by PinkRoccade delivered 
through the MessageLabs Virus Control Centre. For further information visit 
http://www.uk.uu.net/products/security/virus/