RE: Debugging a batch program

["Wills, Mike N. (TC)" <MNWills@xxxxxxxxxxxxxx>]

All, 

Thanks for all the help. With Tyra and Aaron's help I can now debug my
program.

Thanks again...

Mike Wills

-----Original Message-----
From: Wills, Mike N. (TC) [mailto:MNWills@Taylorcorp.com] 
Sent: Wednesday, May 23, 2001 4:31 PM
To: 'RPG400-L@midrange.com'
Subject: Debugging a batch program

How do I debug a batch program? 

I know you can use STRSRVJOB and then use STRDBG. So what I did was put the
jobq on hold (test jobq so it is not a major thing to put on hold) so I
could get the job number. Then used STRSRVJOB on the job, followed by STRDBG
and was going to set a break point, but it wouldn't let me set one.
Something about "cannot perform this function when job is not active". Am I
doing something wrong? The job runs for about 20 seconds normally.

Thanks for any help in advance.

Mike

BTW this is a RPG program.
+---
| This is the RPG/400 Mailing List!
| To submit a new message, send your mail to RPG400-L@midrange.com.
| To subscribe to this list send email to RPG400-L-SUB@midrange.com.
| To unsubscribe from this list send email to RPG400-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator:
david@midrange.com
+---
+---
| This is the RPG/400 Mailing List!
| To submit a new message, send your mail to RPG400-L@midrange.com.
| To subscribe to this list send email to RPG400-L-SUB@midrange.com.
| To unsubscribe from this list send email to RPG400-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---