The target for a numeric operation is too small!!!!!

Maybe someone from IBM T.O. could answer this.

I am creating a report and adding up totals into an 
array.  When I eval the total into a Report Field I
get 
a error. 

Message . . . . :   The target for a numeric operation
is too small to hold the result (C G D F).

Why does it give me a Hard Halt?  and why is there no
"I"?  

Why would the system send a Message to qsysopr or have
a user cancel the program in the middle of a process
because a REPORT Field is To Small...

I have "Truncate numeric . . . . . . . .   *YES" 
on the Create RPG Module.

The field sizes are P(9,2) being put into a P(7,2)
report field.

RPG III is looking better every time I use RPG IV.

The Statement is 

C                   Eval      RPITC1 = RptValx(1) 
On v4r2m0.


K.

_______________________________________________________
Do You Yahoo!?
Get your free @yahoo.ca address at http://mail.yahoo.ca
+---
| This is the RPG/400 Mailing List!
| To submit a new message, send your mail to RPG400-L@midrange.com.
| To subscribe to this list send email to RPG400-L-SUB@midrange.com.
| To unsubscribe from this list send email to RPG400-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---