Re: batch job debugging

[David.Biggs@xxxxxxxxxxxxxxxxxxx]

Use 'STRSRVJOB' (Start Service Job), supplying the fully qualified job name
(number/user/job). Once the service job has started, use STRDBG with your
program as normal. Note however that the job must be active before the STRSRVJOB
command is run. If debugging a short-running job, put in a DLYJOB if possible to
hold up processing until you have established your debug environment.

If your using STRISDB, use the F10 option to display the additional parameters,
and use *SELECT option for the 'Job to service' parameter. The same caveat as
regards the DLYJOB applies.

Hope this helps,
Dave Biggs





+---
| This is the RPG/400 Mailing List!
| To submit a new message, send your mail to RPG400-L@midrange.com.
| To subscribe to this list send email to RPG400-L-SUB@midrange.com.
| To unsubscribe from this list send email to RPG400-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---