Re: Multiple Fields in SFL & Installing PTFs...

>> 3. When I am doing some file oprations(Additions...) with the file
>> declaration as below, I am getting 20 error stating there is no
>> calculation operation for file RPGPGM. But I will compile the
>> program with error seviarity more than 20. Then it compiles and
>> also runs with out any kind of problem with the desired results.
>> Why I am getting error like that. I have Z-add, Move, Write etc.
>> operations for the file also.  
>> F RPGPGM  IF    E        DISK                    A


> I can't figure out why you have declared file as Input and want to do
> an "add" by placing 'A' in file declarstion. It's wrong! Instead of 'I'
> for input it should be 'U' for update.

There is not enough information here to decide the file should be
declared as Input, Output or Update. Either scenario could be
correct depending on how the program is written. If the only file
operations is WRITE, then the file should be designated as Output.
If there are input operations like READ or CHAIN plus output
operations like WRITE, then it should be set as Input with Add. If
there are input operations followed by an UPDAT, then it should be
Update. If there are UPDAT and WRITE, then it is Update with Add.

Joe Teff

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* This is the RPG/400 Discussion Mailing List!  To submit a new         *
* message, send your mail to "RPG400-L@midrange.com".  To unsubscribe   *
* from this list send email to MAJORDOMO@midrange.com and specify       *
* 'unsubscribe RPG400-L' in the body of your message.  Questions should *
* be directed to the list owner / operator: david@midrange.com          *
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *