× The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.


  1.  Home
  2. MIDRANGE-L
  3. July 2022

Re: VIOS fiber channel: Why only one port showing on lsnports?

Le 27/07/2022 à 21:55, Rob Berendt a écrit :
"Assuming". That may be the catch.
Not really sure if I ran the fiber from that port to the switch. Will it only show in lsnports if it is currently wired?
It's only out of state (Grand Rapids MI).

Try "fcstat fcs1" (I guess fcs1 is the device name of T2 port) to check whether it is connected to a switch or not.


There's no "configure and then hook up the wiring" capability, right? You have to wire it up, then configure it?

Once it is connected to a port switch, this port enabled and enabled for NPIV, you have to run "cfgdev -dev fcs1" or "cfgdev" (without device) command for the VIOS to configure the port on the VIOS side.


As an Amazon Associate we earn from qualifying purchases.

This thread ...
Follow-Ups:
Replies:
Follow On AppleNews
Return to Archive home page | Return to MIDRANGE.COM home page

This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].

Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.