FW: Viewing ipds spool files

Hi everyone
We are on V7r3
We create an ipds spool file but when it comes time to actually look at it, the system says that we cannot do so
The following message is displayed
File SKDTAGUK number 1 cannot be displayed, copied, or sent.
Prompting this message, the following is dosplayed
Additional Message Information

Message ID . . . . . . : CPF3429 Severity . . . . . . . : 30
Message type . . . . . : Diagnostic
Date sent . . . . . . : 07/01/22 Time sent . . . . . . : 14:34:42

Message . . . . : File SKDTAGUK number 1 cannot be displayed, copied, or
sent.
Cause . . . . . : File SKDTAGUK number 1 job 181269/SKDTAG45C/TNTITANSC1
created on system NBTYS20 on 07/01/22 12:24:38 cannot be displayed, copied,
or sent. Reason code is 2. If the member option (MBROPT) parameter is
specified as *REPLACE on the Copy Spooled File (CPYSPLF) command, the TOFILE
was cleared.
1 - The file has no records.
2 - The file contains only blank records, graphics, bar codes, or
intelligent printer data stream (IPDS) transparent data.
3 - The file contains only ASCII data intended for a personal computer
printer.
More...

We have to make a change to this spool file, but how can we look at it to determine that the change is good
As we are working from home - printing the spool file will be somewhat difficult
Is there some way via ACS to view this spool file
As always - all responses gratefully accepted


Alan Shore
Solutions Architect
IT Supply Chain Execution

[NHScsignaturelogo]

60 Orville Drive
Bohemia, NY 11716
Phone [O] : (631) 200-5019
Phone [C] : (631) 880-8640
E-mail : ASHORE@xxxxxxxxxxxxxxxxxxxx<mailto:ASHORE@xxxxxxxxxxxxxxxxxxxx>

'If you're going through hell, keep going.'
Winston Churchill