Re: [Power9 with Direct Attached V50x0 -- MIDRANGE-L

× The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.

Ok,

it was "enable"

I'm changing this value to "Transitional". Let me check if this works.

Thanks!

Diego E. KESSELMAN

El 29/07/19 a las 12:18, Steve Pavlichek escribió:

Kristopher does bring up a good point. Double check that the FC ports being used on the v5000 show as “Host IO Permitted”. The fctargetportmode may be set wrong on the v5000. It must be Disabled or Transitional.

v5000 CLI command
Lsiogrp 0

Look for fctargetportmode

From: Diego Kesselman<mailto:diegokesselman@xxxxxxxxx>
Sent: Monday, July 29, 2019 12:39 PM
To: midrange-l@xxxxxxxxxxxxxxxxxx<mailto:midrange-l@xxxxxxxxxxxxxxxxxx>
Subject: Re: [Power9 with Direct Attached V50x0

We don't have virtual wwpns. I remember you need a SAN Switch for that.

El 29/07/19 a las 11:33, Kristopher Whitney escribió:

You need to disable the virtual wwpns (NPIV) on the V5K controller.

-

message: 1
date: Mon, 29 Jul 2019 15:19:32 +0000
from: Tsvetan Marinov <tsetso.marinov@xxxxxxxxx>
subject: Re: Power9 with Direct Attached V50x0

If this is a new V5K, what version of the firmware it is at the moment
and what firmware version it wa shipped with l?

This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].

Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.