RE: Feuding with IBM over HMC console disconnects

I've been fighting that same problem for quite some time as well. Maybe
someone will be at POWERUp19 to gang up on? Wait, we run IBM i and don't
count for the folks in Austin.... Snide comments aside, the correct thing
to do is to stop the console from dropping in the first place.

As to the V7R4, only someone with pre-release would be able to answer the
question. Nothing in the MTU or other documentation I've found.


--
Jim Oberholtzer
Agile Technology Architects

-----Original Message-----
From: MIDRANGE-L <midrange-l-bounces@xxxxxxxxxxxxxxxxxx> On Behalf Of
DrFranken
Sent: Wednesday, May 15, 2019 8:54 AM
To: Midrange Systems Technical Discussion <midrange-l@xxxxxxxxxxxxxxxxxx>
Subject: Feuding with IBM over HMC console disconnects

Opened a PMR with IBM about the way the console works on the HMC. 'Back in
the day' there was a session on the HMC somewhere in the background and if
you got disconnected from the HMC that stayed alive. You could then
reconnect. It was awesome. That went away (I think) with version 7.
(Loooong ago.)

This is of course important for long running tasks like system restores,
full saves from the consoles, PTFs perhaps, things like that.

The 'work around' is to keep a shared console open 'somewhere else'
preferably 'very close' to the HMC so that disconnects are unlikely.
You could do so at the HMC itself of course but that requires the ability to
put the old Mark I eyeball on the HMC. Yes the BMC connection on the 7063
HMC being supported allows this to be done remotely but most customers don't
configure that and even if they do they don't know the user/password for the
thing.

IBM say: "But we gave you console takeover, you're good if you remember to
turn that on!"

*I* say: "But if I get that screen and my password is expired I'm toast."

IBM say: "Correct."

Anyone know if i 7.4 lets you change your password at the takeover screen?

Any other ideas?