I read that BMC must be configured, even if not using it.
6. For HMC model 7063-CR1, you must configure the baseboard management controller (BMC) IP address.
How should BMC be configured for network connectivity?.
Should I used the same network settings as I use for ETH1, which is a static IP?
Or do I configure it like ETH0,
To configure the BMC connection, complete the following steps:
1. In the navigation area, click the HMC Management icon, and then select Console Settings.
2. In the content pane, click Change BMC/IPMI network settings.
3. Select the connection mode (DHCP or Static).
If you select Static mode, complete the following addresses:
* IP address
* Subnet mask
* Gateway
1. Click OK.
You can also configure the BMC network connection by using the Petitboot bootloader interface. For more information, see Configuring the firmware IP address<
https://www.ibm.com/support/knowledgecenter/linuxonibm/liabw/liabwenablenetwork.htm?view=kc>.
Paul
-----Original Message-----
From: MIDRANGE-L [mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of DrFranken
Sent: Friday, December 07, 2018 8:53 AM
To: Midrange Systems Technical Discussion
Subject: Re: HMC 7063-CR1 BMC - baseboard management controller
Not required, true. Useful YES.
Look up "IPMI" under supermicro. This is what's running there.
Most x86 HMCs had IBM/Lenovo's equivalent to this however you had to add
a key to actually be able to use the system remotely with this. It also
was NOT recommended by IBM. They claimed somethihng about the BIOS could
change and so you shouldn't use or update the code etc. So most folks
didn't use it though some did and found it useful.
With IPMI you'll find a pretty full function management interface for
the HMC. You can power it up and down, update firmware, and importantly
access the boot screens remotely. You may want to look up IPMITOOL but
these use a new enough firmware that it will work in a modern browser.
- Larry "DrFranken" Bolhuis
www.Frankeni.com
www.iDevCloud.com - Personal Development IBM i timeshare service.
www.iInTheCloud.com - Commercial IBM i Cloud Hosting.
On 12/7/2018 8:32 AM, Steinmetz, Paul wrote:
HMC 7063-CR1 BMC - baseboard management controller.
The BMC is the baseboard management controller and provides the management and monitoring functions for the boot process and the OPAL hypervisor. It fulfills many of the functions that the ASMI provided on the other Power Systems servers.
So what does this all mean?
Is BMC required?
This didn't exist on the order HMCs, correct?
Thank You
_____
Paul Steinmetz
IBM i Systems Administrator
Pencor Services, Inc.
462 Delaware Ave
Palmerton Pa 18071
610-826-9117 work
610-826-9188 fax
610-349-0913 cell
610-377-6012 home
psteinmetz@xxxxxxxxxx
http://www.pencor.com/
--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit:
https://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at
https://archive.midrange.com/midrange-l.
Please contact support@xxxxxxxxxxxx for any subscription related questions.
Help support midrange.com by shopping at amazon.com with our affiliate link:
https://amazon.midrange.com
As an Amazon Associate we earn from qualifying purchases.