Re: QShell performance

Scott, et al,

I tried various suggestions, then took Diego's advice to look at CHGTCPDMN. There was a DNS address specified that is either invalid or blocked by the firewall. After removing that address "hostname" comes back immediately as does the string with the "ls" command embedded: QSH CMD('cd /usr/Mark/Downloads/;for file in *.h37;do ls "$file";done'). I haven't tested the command with the "mv", but I assume that it will follow suit.

Thanks to all that responded, for the suggestions.

For good measure, I put the invalid address back in, just to make sure that it wasn't a fluke. Sure enough, the old long lag times returned! Even removing the address while the command was running caused the list to start flying by. Any ideas why this would occur?

-mark

On 6/19/2017 1:36 AM, Scott Klement wrote:

Mark,

Something isn't right here -- 25 seconds to run a "mv" command? It should be sub-second. Is your subsystem low on resources?

Your second example, with the "ls" might be slow if it's a very big directory. That one is not a good way to do things... but. the first one shouldn't be too bad. The biggest performance issue, as I see it, is calling "basename" since that will launch a whole new job each time you run it.

But, even with that, I don't get why it'd take 25 seconds.