Re: Is there any way to retrieve entries from SAL and PAL

I found it! Here's a snip it from an Internet page

"Easiest to start would perhaps be to obtain/install/study Albert York’s TNAPI
utility <http://think400.dk/downloads.htm>. IIRC, it explicitly connects to
the System i telnet server itself; but once that’s done, you can pass in
the TELNET command as if you were running green-screen and go from there.
It’s not intended for outbound connections, but I don’t think there’s any
way it knows that outbound is being established inside of it."

Here is where to find it http://think400.dk/downloads.htm



On Fri, Feb 5, 2016 at 5:22 AM, <rob@xxxxxxxxx> wrote:

The closest API (other than the roll your own macro API mentioned by
another) is an API for WRKPRB. But other than that I'm not seeing a whole
lot


http://www-01.ibm.com/support/knowledgecenter/ssw_ibm_i_72/apis/aplist.htm?lang=en-us
Problem Management
Miscellaneous / Service-related APIs



Rob Berendt
--
IBM Certified System Administrator - IBM i 6.1
Group Dekko
Dept 1600
Mail to: 2505 Dekko Drive
Garrett, IN 46738
Ship to: Dock 108
6928N 400E
Kendallville, IN 46755
http://www.dekko.com

--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/midrange-l.

Please contact support@xxxxxxxxxxxx for any subscription related
questions.