lol...ok I'll use the top port...
Now is that's the
A) top port (T1) all by itself on the left hand side as you are looking at
B) the top port on the 2 port stack on the left hand side..
C) the top port on the 4 port card on the right...
If A), that's where I had the cable, but I've got a A9002000 src being
What did I do wrong? Do I need a cross pinned ethernet cable? It's not
mentioned, but seems strange to run a straight through cable direct.
On Tue, Nov 24, 2015 at 2:53 PM, DrFranken <midrange@xxxxxxxxxxxx> wrote:
T1. Top port. Always top port OR you could use the top port, either way.
- Larry "DrFranken" Bolhuis
www.iDevCloud.com - Personal Development IBM i timeshare service.
www.iInTheCloud.com - Commercial IBM i Cloud Hosting.
On 11/24/2015 2:36 PM, Charles Wilt wrote:
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing
Which port do I connect to the PC for the initial console setup?
ACS docs say T1, Hardware infocenter mentions T4, T5
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives