|
We had an unanswered message in QSYSOPR late yesterday afternoon that
caused issues after hours and this morning. I'm looking at ways to monitor
QSYSOPR. I googled and found instructions for setting up a message monitor
in Management Central for QSYSOPR message queue.
I expanded Management Central/Monitors. When I right-click "Message" then
"New Monitor" it fails with the following in the joblog:
Additional Message Information
Message ID . . . . . . : CPFB92A
Date sent . . . . . . : 08/19/15 Time sent . . . . . . :
11:22:04
Message . . . . : Unexpected exception occurred during Management
Central
protocol.
Cause . . . . . : An unexpected protocol exception occurred on system
I5.DILGARDFOODS.COM.
Recovery . . . : If the problem persists, contact service.
followed by:
Additional Message Information
Message ID . . . . . . : CPFB96B
Date sent . . . . . . : 08/19/15 Time sent . . . . . . :
11:22:04
Message . . . . : Authentication failed for request from user JEFF on
system
JLCROSBY.
Cause . . . . . : The Management Central server on system
MYIBMI.MYCOMPANY.COM was not able to authenticate the request from
system
JLCROSBY using protocol 8192. The protocols are: 1024 and 8192 -
Profile/Password protocol, 512 - Kerberos protocol.
Recovery . . . : For protocol 1024 and 8192, profile and password
authentication is being used. Check previous messages for more
information.
Verify that the user profile exists on each system with the
appropriate
granted authorities and submit the request again. For protocol 512,
Kerberos authentication is being used. Check previous messages for
more
information. Verify that Kerberos is properly configured on both
systems
and submit the request again.
Googling CPFB92A results in few hits, one of which says
"The following IBM document may very easily have the answer to the
problem, however it is restricted and you have to have PartnerWorld
access to get to it. Why do they restrict documents like this? 29531900,
Cannot Start Monitors Because of Messages CPFB92A and CPFB96B"
I googled that document and found zilch.
Management Central server is running, though I don't remember ever using
it much. System i 520, V7R1, pretty current on PTFs. I'm using my signon
(*ALLOBJ authority) in System i Navigator. QSECOFR is not disabled.
Suggestions? Should I change Management Central to use IP address instead
of MYIBMI.MYCOMPANY.COM?
Thanks.
--
Jeff Crosby
VP Information Systems
UniPro FoodService/Dilgard
P.O. Box 13369
Ft. Wayne, IN 46868-3369
260-422-7531
www.dilgardfoods.com
The opinions expressed are my own and not necessarily the opinion of my
company. Unless I say so.
As an Amazon Associate we earn from qualifying purchases.
This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.