On 12/11/2013 4:11 PM, Jerry Draper wrote:
We use the MONUPSPWR CL IBM gives us to monitor a msgq for UPS statuses.

We take appropriate action depending on what messages we get (or not).

Now we have a situation where we have redundant AC on our IBMi connected
to two different UPS systems. (redundency of the redundent).

We only have one port on the IBMi for a UPS sensor cable.

IBM suggests a box with two UPS inputs to resolve to one UPS cable that
attaches to the IBMi so if either UPS system said we were on UPS we
would act as though we were on UPS.


I think the consensus is rapidly forming that there's no commercial box
that 'combines' the outputs of multiple UPS units. That puts you in DIY
land. Generally speaking, if I say 'diode or' and you say 'huh?' it's a
signal to me that I should advise you to hire this out locally.


On 12/11/2013 12:48 PM, Roberto José Etcheverry Romero wrote:
Depends on one's need. I would like my system to stay up if one grid lost
power but the other was OK (not running on battery). Some people might
to start a shutdown when only one of them fails. The Arduino path is
what i
meant when i said a tinkerer is the best choice to implement this, i'm 26
but i would've done it with logic gates, even simpler (less points of
failure, unless you want TCPIP monitoring, which an arduino can give

On Wed, Dec 11, 2013 at 5:32 PM, DrFranken <midrange@xxxxxxxxxxxx> wrote:

Would you want the system to power down if only one UPS lost grid power?
Would you want the system to power down if BOTH UPS lost input power?

Looking to understand the logic in the magic box because an Arduino
could do this very very easily.

- Larry "DrFranken" Bolhuis


On 12/11/2013 2:07 PM, Jerry Draper wrote:

We have an 8202-E4D with redundant power supplies (2 AC).

Mgmt wants to connect each AC to a different UPS for UPS redundancy.

We only have one port for the RJ45 UPS sensor cable (P1-T2).


IBM suggested that we could build a box with two RJ45 in and one RJ45
out (or two DB9 to one DB9) that would detect UPS status from either
and send one signal to the IBMi.

Anyone have this box or know where to get one?



This thread ...


Follow On AppleNews
Return to Archive home page | Return to MIDRANGE.COM home page

This mailing list archive is Copyright 1997-2020 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].