Re: How to debug a message monitor?

Buck,

Trying to understand more.

On the failed monitor, when you right click does it give you the option to
reset the triggers? Does it put the monitor back in a "GREEN" status?

In Properties, on the messages tab is the "Automatically reset after
trigger command has run" checked?

I have had to call IBM with several monitor issues, and have had good
response in getting them to solve "Failed" server issues.

On Tue, Sep 10, 2013 at 11:27 AM, Buck Calabro <kc2hiz@xxxxxxxxx> wrote:

I have a message monitor set up in IBM i Navigator. When it triggers,
it goes into 'Failed' status. I've tried creating a new one, same
thing. I'm one quarter behind on PTFs on my 7.1 system, and current on
IBM i Access.

Verify Central Systems Connection reports all green check marks.
Diagnostics reports that under Network Settings > Response time it was
unable to connect to my IBM i. Under Response Time to System i
Navigator, it reports 2ms response time except for Management Central
which is 123ms (which Diagnostics declares is 'within reasonable limits.')

The Management Central manual in the Infocenter hasn't got a
troubleshooting section. There are no obvious job logs and QHST hasn't
got any interesting entries. dspjob QYRMJOBSEL reports 'Job //QYRMJOBSEL
not found.'

Where do I find the information to debug the reason behind this monitor
failing out?
--buck
--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/midrange-l.