×
The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.
I have a message monitor set up in IBM i Navigator. When it triggers,
it goes into 'Failed' status. I've tried creating a new one, same
thing. I'm one quarter behind on PTFs on my 7.1 system, and current on
IBM i Access.
Verify Central Systems Connection reports all green check marks.
Diagnostics reports that under Network Settings > Response time it was
unable to connect to my IBM i. Under Response Time to System i
Navigator, it reports 2ms response time except for Management Central
which is 123ms (which Diagnostics declares is 'within reasonable limits.')
The Management Central manual in the Infocenter hasn't got a
troubleshooting section. There are no obvious job logs and QHST hasn't
got any interesting entries. dspjob QYRMJOBSEL reports 'Job //QYRMJOBSEL
not found.'
Where do I find the information to debug the reason behind this monitor
failing out?
--buck
As an Amazon Associate we earn from qualifying purchases.
This mailing list archive is Copyright 1997-2025 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact
[javascript protected email address].
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.
midrange.com
