Re: V7R1 Parameters do not match those in program QSRVALID in QSYS.

Found a possible solution athttp://www-01.ibm.com/support/docview.wss?uid=nas8N1011819

-----Original Message-----
From:midrange-l-bounces@xxxxxxxxxxxx [mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Don Osmond
Sent: Saturday, August 31, 2013 1:45 PM
To:midrange-l@xxxxxxxxxxxx
Subject: V7R1 Parameters do not match those in program QSRVALID in QSYS.

We upgraded V5R4 to V7R1 and now when I try to run SAVLIB I get the error "Parameters do not match those in program QSRVALID in QSYS" with details as

Message ID . . . . . . : CPD0162 Severity . . . . . . . : 30
Message type . . . . . : Diagnostic
Date sent . . . . . . : 08/31/13 Time sent . . . . . . : 13:27:10

Message . . . . : Parameters do not match those in program QSRVALID in QSYS.
Cause . . . . . : The number of parameters in the command definition do not
match the number of parameters in the command processing or the validity
checker program QSRVALID in library QSYS.
Recovery . . . : If the command was not supplied by IBM, determine if the
correct command processing program or validity check program called. If the
program that was called is not correct, change the program name or the
library name specified on the Create Command (CRTCMD) command. If the
correct program was called, change the number and type of parameters in the
command definition source to match the number and type of parameters
specified in the command processing program. If the command was supplied by
IBM, report the problem (ANZPRB command).

Any ideas on our to resolve this?

[Description: CTA logo JPEG small]Donald (Don) P. Osmond, CTO Carolina Technology Associates, LLC