Re: From HMC to No-HMC?

In this case, it's a simple 525, one partition, LS on the integrated
5709. I had more trouble remembering that i had to both change the
partitions "console" iop and then actually change the console type on
DST than i can have moving those switches, i really hoped there was an
easier way.
But yes, multicontroller systems or multi partition systems converted
to single partition should take care with the LS location.
Thanks for all!


On Fri, Oct 26, 2012 at 8:17 PM, Evan Harris <auctionitis@xxxxxxxxx> wrote:

You might want to check that the load source disk is on the default controller.

On Sat, Oct 27, 2012 at 10:10 AM, Roberto José Etcheverry Romero
<yggdrasil.raiker@xxxxxxxxx> wrote:

Hello all,


I've seen some cases where new POWER systems come pre-tested from IBM
configured to use HMC and it was a pain to change back. Now, how do
you change the service processor to stop being managed by the HMC? (in
this case i have a 525 with 1 partition that i want to move beyond the
reach of the HMC that used to control it). I think it had to do with
doing a factory reset on the ASMI but i figured i'd rather ask first
before having to re-configure the Service Processor...

Best Regards


Roberto

--

Regards
Evan Harris
--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/midrange-l.