Re: From HMC to No-HMC?

[Evan Harris <auctionitis@xxxxxxxxx>]

You might want to check that the load source disk is on the default controller.

On Sat, Oct 27, 2012 at 10:10 AM, Roberto José Etcheverry Romero
<yggdrasil.raiker@xxxxxxxxx> wrote:
> Hello all,
>
>
> I've seen some cases where new POWER systems come pre-tested from IBM
> configured to use HMC and it was a pain to change back. Now, how do
> you change the service processor to stop being managed by the HMC? (in
> this case i have a 525 with 1 partition that i want to move beyond the
> reach of the HMC that used to control it). I think it had to do with
> doing a factory reset on the ASMI but i figured i'd rather ask first
> before having to re-configure the Service Processor...
>
> Best Regards
>
>
> Roberto