Re: TCP/IP starts twice in V7

[ankush agrawal <aankush39@xxxxxxxxx>]

Hi Jim,

"Client machine keeps crashing the Telnet Server."

This is the issue with V7R1. After upgrading from V5R4 to V7R1, we also
faced the same problem.

I would suggest you to try this.

ENDTCP before ENDSBS *ALL *IMMED

If the Telnet server is not ended prior to the ending of subsystems, it
might not automatically restart. To circumvent this and other potential
problems it is suggested that prior to ENDSBS *ALL *IMMED these steps be
taken:

1. ENDTCPSVR *ALL
2. ENDHOSTSVR *ALL
3. Allow the commands to complete and the servers to end. If issuing the
commands from a CL program include a DLYJOB DLY(300) to allow the commands
to complete.
4. ENDTCP


Also, there are PTF's recommended by IBM.


Thanks

On Tue, Sep 18, 2012 at 3:38 PM, Paul Nelson <nelsonp@xxxxxxxxxxxxx> wrote:

> I ran into this one the other day. IBM first had me bounce the telnet
> server
> using the HMC, and then when I could get to QINTER, change the IPL
> attribute
> to not start TCP, and then change the boot program to start the subsystems
> first, and then issue the STRTCP command down at the end of the program,
> with a 2 minute delay. This is then followed by starting a couple of tcp
> servers needed for the application software.
>
> Mind you, this machine was upgraded in February. He told me TCP has been
> flaky since it was rewritten for V6R1, and it was dumb luck this hadn't
> happened previously.
>
> There are also a few ptf's that are not part of a package yet.
>
> Paul Nelson
> Cell 708-670-6978
> Office 512-392-2577
> nelsonp@xxxxxxxxxxxxx
>
> -----Original Message-----
> From: midrange-l-bounces@xxxxxxxxxxxx
> [mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Jim Oberholtzer
> Sent: Tuesday, September 18, 2012 2:51 PM
> To: Midrange Systems Technical Discussion
> Subject: TCP/IP starts twice in V7
>
>  Folks,
>
> This one has me stumped.  Client machine keeps crashing the Telnet
> Server.  IBM says the reason is TCP is starting twice.  Nice, except
> there is not STRTCP command anywhere in the start up stream that we know
> of (I retrieved the cl source of the start up program to be sure)   IPL
> attributes are set to start TCP.
>
> Any ideas?
>
> --
> Jim Oberholtzer
> Chief Technical Architect
> Agile Technology Architects
>
> --
> This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
> To post a message email: MIDRANGE-L@xxxxxxxxxxxx
> To subscribe, unsubscribe, or change list options,
> visit: http://lists.midrange.com/mailman/listinfo/midrange-l
> or email: MIDRANGE-L-request@xxxxxxxxxxxx
> Before posting, please take a moment to review the archives
> at http://archive.midrange.com/midrange-l.
>
>
>
> --
> This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
> To post a message email: MIDRANGE-L@xxxxxxxxxxxx
> To subscribe, unsubscribe, or change list options,
> visit: http://lists.midrange.com/mailman/listinfo/midrange-l
> or email: MIDRANGE-L-request@xxxxxxxxxxxx
> Before posting, please take a moment to review the archives
> at http://archive.midrange.com/midrange-l.