RE: create command - how to have a blank line during command prompt

I am assuming that the requirement for a blank line means an *INTERACTIVE or
*IPGM execution.

If the blank line was absolutely necessary, I would cheat and use a display
file in the CPP. That would put the user interface firmly under my control.
I know it would not be quite the same thing as a real command, but you can
get quite close to the look-and-feel without too much effort.



Regards

Jeff Bull
iSeries Technical Consultant
NYCO Ltd - iSeries & AS/400 Automation Specialists
Tel: +44(0)20 8416 3778
Fax: +44(0)20 8416 3779
Mobile: +44(0)77 5692 3335
Email: jeff.bull@xxxxxxxxxx
Website: www.nyco.co.uk

-----Original Message-----
From: midrange-l-bounces@xxxxxxxxxxxx
[mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Timothy Adair
Sent: 18 May 2012 20:43
To: midrange-l@xxxxxxxxxxxx
Subject: Re: create command - how to have a blank line during command prompt

Joel,

I had this same question a while back. Here's the link - maybe you could
try some of the suggestions.

http://archive.midrange.com/midrange-l/201008/msg00077.html


~TA~







"Stone, Joel" <Joel.Stone@xxxxxxxxxx> wrote in message
news:mailman.3744.1337363070.23162.midrange-l@xxxxxxxxxxxx...
I would like to create a command and see some blank lines between some parms
when prompting the command.

Is this possible - without adding parms what wont be used?

Thanks

--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx To subscribe, unsubscribe,
or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx Before posting, please take a
moment to review the archives at http://archive.midrange.com/midrange-l.