Re: BRMS: I do not want to come out of restricted state -- MIDRANGE-L

× The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.

If your going to IPL right away after the save finishes, have the control group do it for you. Use option 8 on your control group inside the command WRKCTLGBRM. In there you can set the IPL settings. Hint: It's on the 3rd page down and usually defaults to the back up policy.

Also as a further note, check the IPL controls in system policy. If the control group finishes outside the time IPL time allotment you will get an error message and the IPL will not happen.

Jim Oberholtzer
Chief Technical Architect
Agile Technology Architects

On 12/7/2011 10:02 PM, rob@xxxxxxxxx wrote:

When doing a STRBKUBRM CTLGRP(DTFULL) SBMJOB(*NO) OMITS(*IGNORE) where
DTFULL is a control group with these entries
Backup List ASP
Items Type Device

*SAVSYS
*IBM
*ALLUSR *SYSBAS
*ALLDLO
*LINK *ALLAVL

and I had the system in restricted state. Upon completion it starts the
controlling subsystem. I do not wish it to do so as I normally IPL and
that right after this step. What do I need to do?

Rob Berendt
-- Group Dekko Dept 1600 Mail to: 2505 Dekko Drive Garrett, IN 46738 Ship to: Dock 108 6928N 400E Kendallville, IN 46755 http://www.dekko.com
--

This mailing list archive is Copyright 1997-2025 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].

Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.