|
I just ran a test in which I am trying to replace a ubiquitous OCL procedure
with an equivalent IBM i command. Because the OCL is in just about every
other OCL procedure, I gave the command the same name (say, TEST). But if I
key TEST on the command line, it retrieves and runs the 36EE OCL. I
couldn't find anything in the CHGS36 command that would allow me to change
the precedence whereby the system would look for an IBM i command *before*
it reverted to OCL procedures/commands. Is there any way to change the
precedence?
Thanks.
Jerry C. Adams
IBM i Programmer/Analyst
No man can have in his mind a conception of the future, for the future is
not yet. But out of conceptions of the past, we make a future. -Thomas
Hobbes
--
A&K Wholesale
Murfreesboro, TN
615-867-5070
--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/midrange-l.
As an Amazon Associate we earn from qualifying purchases.
This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.
midrange.com
