Re: clear msg

No you have to use clrmsgq command and for the queue name use program name.

Use normal dspf opening method(allow system to open it for you)


Regards,

Chamara Withanachchi
IBM Certified Power System Expert
RPG Programmer
(owner of www.rpgiv.info)

WWW.RPGIV.INFO
Mob: +971 50 5698644
Tel: +971 6 5595887
chamaraw@xxxxxxxxxx
www.rpgiv.info
i want to be future ready. i want control. i want an i.


Sent from my BlackBerry® wireless device

-----Original Message-----
From: Bob Bledsoe <bledsoe.bob@xxxxxxxxx>

Date: Fri, 13 Mar 2009 14:08:12
To: Midrange Systems Technical Discussion<midrange-l@xxxxxxxxxxxx>
Subject: Re: clear msg


Opening the dspf after the clear dosen't seem to matter. I still get the
message. But thanks.

Bob B

On Fri, Mar 13, 2009 at 1:44 PM, Booth Martin <booth@xxxxxxxxxxxx> wrote:

I may not be following you here, but could you have the dspf be user
open and not open it until after you have done the clrpfm?

Bob Bledsoe wrote:

I have a dspf with a msg control file on it. At the begging of the

program I

do a clrpfm and the message that it has been cleared shows on the

display.

How do I clear that msg so it will not display?

Thanks,

Bob B

--
---------------------------------
Booth Martin
http://www.Martinvt.com <http://www.martinvt.com/>
---------------------------------

--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/midrange-l.