Re: Qshell command

[Scott Klement <midrange-l@xxxxxxxxxxxxxxxx>]

Alan,

An easier way than looking up the 3489 in that source member would've 
been to type the following at the command line:

   DSPMSGD CPE3489

However, I could not be certain what that message was in regards to, 
since your job-log snipped omitted the text describing reason code 4.  I 
would've looked up the 2nd-level text of the message on my own system, 
but your job log snippet also omitted the msgid.

But, any any rate, when you see a reference to 'errno', you can 
generaally get a description of the error by typing DSPMSGD CPExxxx 
where xxxx is the error number.


Alan Shore wrote:
> Tommy (and obviously Scott Klement)
> MUCH appreciated
> Thanks