You have spool files associated with the job. Put an 8 on the option line
and decide if you want to print or delete the spool files then the job
should disappear.
Regards,
Guy
Don Wereschuk
<dwereschuk@simcoepa To: Midrange Systems Technical Discussion <midrange-l@xxxxxxxxxxxx>
rts.com> cc:
Sent by: Subject: Remove Batch job OUTQ
midrange-l-bounces@m
idrange.com
12/20/2007 11:23 AM
Please respond to
Midrange Systems
Technical Discussion
Hi All: I have a batch job that starts every morning and runs till a
specified time. Last night the job went to a status of HLD and thus did not
end. A new batch job with the same JOBD was started again this morning. The
problem is that I still have the old job on the system with an OUTQ that I
cannot get rid of. Below is a listing that shows all the duplicate jobs.
Entered
Option Job User Number Type -----Status----- System
UPDNIN QPGMR 588663 BATCH ACTIVE
20/12/07
UPDNIN QPGMR 587223 BATCH OUTQ
20/12/07
UPDNIN QPGMR 568022 BATCH OUTQ
19/12/07
I need to remove the bottom two jobs so that the active job will run
properly. I've done this before but I'm running low on memory and can't
recall how I did this. Can anyone help. I've tried different delete's,
clear's and end's but I don't want to get rid of some object that I'll have
to replace for the program to run normal again. TIA.
Don Wereschuk
ISD - Programmer/Analyst
Simcoe Parts Service Inc.
Phone: 705-435-7814 Ex: 302
Fax: 705-435-6746
mailto:dwereschuk@xxxxxxxxxxxxxxx
******************************************
"Save the Cheerleader - Save the world" - Hiro Nakamura
--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit:
http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at
http://archive.midrange.com/midrange-l.
midrange.com
