|
How do I tell if IT Director is running (programmatically)?
In iNav I can click on
Network, Servers, User Defined, and that tells me if it is started.
It is currently started.
Tried right clicking and selecting server jobs. None appeared.
Statement of problem:
Tried to vary on an iScsi. Died with CPD22B4, error number 3489. Refers
you to CPE3489. Which refers you to your Ouija board. Additional message
in the joblog that tried the vary on is CPFC40E-Cannot connect to IBM
Director Server, reason code 4. Which says:
Wait five minutes and try again. If you are still unable to connect to
Director Multiplatform, end and restart the *DIRECTOR TCP/IP server by
specifying ENDTCPSVR SERVER(*DIRECTOR) and STRTCPSVR SERVER(*DIRECTOR).
Repeat the request.
Director is set to start when TCP/IP is started. The VRYCFG wasn't ran
until 25 minutes after the system was started.
Rob Berendt
--
Group Dekko Services, LLC
Dept 01.073
PO Box 2000
Dock 108
6928N 400E
Kendallville, IN 46755
http://www.dekko.com
--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/midrange-l.
As an Amazon Associate we earn from qualifying purchases.
This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.
midrange.com
