Re: Shutting Down prior to moving iSeries

Moving a system is the one occasion where doing a backup by SAVSTG is a
good solution.  It does a dump of the entire system at the byte level.
Spool and the whole 9 yards.  You are going from the one system to the same
system.  Same exact configuration.  SAVSTG make sense.  (I would also do a
GO SAVE 21.)

Al

Al Barsa, Jr.
Barsa Consulting Group, LLC

400>390

"i" comes before "p", "x" and "z"
e gads

Our system's had more names than Elizabeth Taylor!

914-251-1234
914-251-9406 fax

http://www.barsaconsulting.com
http://www.taatool.com
http://www.as400connection.com



                                                                           
             "Norbut, Jim"                                                 
             <Jim.Norbut@Grubb                                             
             -Ellis.com>                                                To 
             Sent by:                  <midrange-l@xxxxxxxxxxxx>           
             midrange-l-bounce                                          cc 
             s@xxxxxxxxxxxx                                                
                                                                   Subject 
                                       Shutting Down prior to moving       
             03/09/2006 11:00          iSeries                             
             AM                                                            
                                                                           
                                                                           
             Please respond to                                             
             Midrange Systems                                              
                 Technical                                                 
                Discussion                                                 
             <midrange-l@midra                                             
                 nge.com>                                                  
                                                                           
                                                                           




Hi All,

We are going to be moving our 9406 next month to a new location
and have all the plans set as far as moving it to the new spot about 30
miles away.
Movers/Insurance all taken care of.

IBM was more than willing to help us.....and we were intrigued until
they said how much it "potentially" would cost :) We figured the
figure they quoted us was the "low end".

We have 24/7 Coverage on the iSeries....so if something decides to not
spin up
or something "breaks" we can just call if/when it comes to that on the
Friday night/Saturday when we turn it back on.

I called up IBM inquiring about any special shutdown procedures we
should be aware
of prior to the move but they said other than due diligence there is no
real checklist to follow.

There is no need to worry about parking the drive heads or anything like
that with these
machines like you used to have to worry about.

So that seems to me to say:

A) Do a full backup (potentially 2) and keep the backup(s) with me.
B) Do the PWRDWNSYS command with no startup
C) Label all the cables (where they go.....where they came from)

Does anybody have any other suggestions ?








--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/midrange-l.